If the mattress has a flocked or textured surface gently sandpaper the area of the leak exposing the flat vinyl.
Duct tape fix air mattress.
Cut a strip of duct tape long enough to cover the puncture completely and press it firmly onto the air mattress.
Spread epoxy glue or rubber cement over the hole or rip in the air mattress and allow it to dry completely.
It will dry and fall.
Using a patch kit 1.
You don t want any air getting under your patch and ruining the glue so let all the.
Most importantly check your air mattress warranty to know if you can still get a refund or replacement.
How to use duct tape to fix the air mattress step 1.
But if you don t have the choice you can use duct tape to stop the air from coming out of your mattress.
Clean off the damaged area then lay the tape flat over the hole.
Replace it with a stronger patch when you get the chance.
Buy a patch kit.
Fill it until the.
Connect the pumping device to the inflation valve of the mattress and then inflate it.
You will be able to use the mattress for the night but the tape will loosen over time.
Then firmly press the tape onto the air mattress.
Put the air mattress in a bright quiet room.
This will help you to identify where the hole is because you will.
How to use duct tape to fix an air mattress step 1.
Right after confirming that the mattress is leaking and marking out the leaking area go ahead to deflate the.
Temporarily seal holes with duct tape.
Most of the air mattresses available today are provided with lifetime warranties.
You can decide to use duct tape and even though it is effective in the short term.
First check if any open seams need to be mended.
They are small cheap sets that.
Once the leak has been located mark it with a permanent marker and thoroughly clean the area allowing it to dry.
Sand away any soft felt near your.
Duct tape is not a wise solution to your problem.
If the tape is strong enough not to fail you will probably run into a couple other problems when.
Almost every outdoor store will have these in the camping section.
This is a video of how to patch a hole in an air mattress.
After some time the glue on the duct tape will come out as it will not permanently bind it to the plastic.
Completely deflate the mattress.
Take the duct tape and cut a strip out of it.